|
| |
TANK
LEVEL MONITORING, DISPLAY, ALARM & CONTROL SYSTEMS |
AIM FUEL -TA TANK ALARM
CONTROLLER
FUEL TANK, LEVEL DISPLAY UNIT WITH HIGH
AND LOW LEVEL ALARMS.
This compact, easy to use, self-contained, flush mount module
provides reliable tank level display with independent high and
low alarm controls for your fuel tank.
 |
Including
- 20 LED bargraph display of tank level.
- Tank low level, audible and visual alarms.
- Tank high level audible and visual alarms.
- Sealed touch switch controls for greater reliability.
- Test switch performs full test sequence.
- Separate High and Low Audible alarm isolate switch.
- Fault monitoring of tank sensor input.
- Visual sensor fault warning.
- Status display back illuminated by LED lightbars
for instantaneous status recognition.
- Compact sealed enclosure 48 x 96 x 150 mm deep.
- Plug-in terminals for all wiring on rear. Refer over.
- Two independent Remote Alarm Relay outputs.
|
| Tank Level Monitoring
Sensor mounting options
This system utilises our TLMP-98 Solid
State Pressure Transducer to measure the depth of liquid
remaining in the tank.
Has no moving parts to break or give trouble. Sensor housed
in 316 stainless steel enclosure
38(dia) x 65(h) mm with stainless steel 1/2" BSPT(m)
mounting thread and sensing tube. |
 |
The ITIM Systems AIM-TA98 Tank Alarm Controller module has
an eight (8) way plug-in terminal on the rear for connection
of all external wiring.
Terminals 1 & 2. Power in. 12 or 24 VDC. 1. = Battery
-ve 2. Battery +ve
Terminals 3 & 4. Tank Level Sensor. 3. Sensor -ve (Return)
4. Sensor +ve (Feed).
Terminals 5 & 6. Remote High Alarm. 5. High Alarm -ve
6. High Alarm +ve (1A).
Terminals 7 & 8. Remote Low Alarm. 7. Low Alarm -ve
8. Switched +ve. (1A) |
AIM - TA TANK
ALARM CONTROLLER
HAS SIX TRIM POT ADJUSTMENTS
THESE ARE PRESET TO SUIT YOUR TANK
BUT CAN BE ADJUSTED IF REQUIRED
AIM - TA98 FUEL TANK ALARM CONTROLLER
TURN HIGH & LOW ALARM TRIP-POINTS
CLOCKWISE TO LOWER TRIP-POINT
ANTI-CLOCKWISE TO RAISE
TURN BAR-GRAPH FULL & EMPTY
ADJUSTMENTS CLOCKWISE
TO RAISE DISPLAY LEVEL,
ANTI-CLOCKWISE TO LOWER.
THE CALIBRATION JUMPER DOES NOT
NEED TO BE SET IF MAKING FINE LEVEL
ADJUSTMENTS.
|
 |
|
Innovative Technology for Industry and Marine
P.O. Box 218 Red Hill, Qld 4059, Australia
|
4 Cramond Street,
Wilston, Qld 4051, Australia
ISD + 61 7. Phone (07) 3356 1276. Fax (07) 3356 5693 |
|
