|
TANK
LEVEL MONITORING, DISPLAY, ALARM & CONTROL SYSTEMS |
AIM BLACK WATER-TC Tank Controller
BLACK WATER TANK, LEVEL DISPLAY, ALARM &
PUMP CONTROL MODULE
This compact, easy to use, self-contained, flush mount module provides
remote tank level display, manual start / auto off, pump out control,
pump out due warning & tank full alarms for your black water tank.
 |
- Sealed touch switch controls for greater reliability.
- Manual pump out start switch, auto or manual pump off.
- Remote 10 Amp C/O pump control relay.
- Audible alarm isolate / reset switch.
- Fault monitoring of tank sensor input.
- Visual sensor fault warning.
- Status display back illuminated by LED lightbars
- for instantaneous status recognition.
- Compact sealed enclosure 48 x 96 x 150 mm deep.
- Plug-in terminals for all wiring on rear. Refer over.
- Remote high level alarm relay output.
- Test switch performs full test sequence.
|
TLMP-98 Tank Level
Monitoring Probe Mounting Options
This system utilises our Solid State Pressure Transducer to measure
the depth of liquid remaining in the tank. Has no moving parts
to break or give trouble.
Sensor housed in 316 stainless steel enclosure 38(dia) x 65(h)
mm with stainless steel 1/2" BSPT(m) mounting thread and
sensing tube. |
 |
Terminals 1 & 2. Power in. 12 or 24 VDC. 1. = Battery -ve
2. Battery +ve
Terminals 3 & 4. Tank Level Sensor. 3. Sensor -ve (Return) 4.
Sensor +ve (Feed).
Terminals 5 & 6. Remote Alarm. 5. Remote Alarm -ve 6. Remote
Alarm +ve (1A).
Terminals 7 & 8. Remote Pump Control Relay. 7. -ve 8. Switched
+ve. (1A ). |
| The ITIM Systems AIM-TC98 Tank Controller module has an eight
(8) way plug-in terminal on the rear for connection of all external
wiring. |
|
THE AIM-TC HAS SIX MULTI-TURN TRIM POT ADJUSTMENTS
ON THE REAR THESE ARE PRESET TO SUIT YOUR TANK DEPTH BUT CAN BE ADJUSTED
IF REQUIRED
AIM-TC98 BLACK WATER TANK CONTROLLER ALARM AND PUMP TRIP-POINTS CLOCKWISE
TO LOWER TRIP-POINT ANTI-CLOCKWISE TO RAISE BAR-GRAPH FULL & EMPTY
ADJUSTMENTS CLOCKWISE TO RAISE DISPLAY LEVEL, ANTI-CLOCKWISE TO LOWER.
THE CALIBRATION JUMPER DOES NOT NEED TO BE SET IF MAKING FINE LEVEL
ADJUSTMENTS.
Innovative Technology for Industry and Marine
P.O. Box 218 Red Hill, Qld 4059, Australia
|
4 Cramond Street, Wilston,
Qld 4051, Australia
ISD + 61 7. Phone (07) 3356 1276. Fax (07) 3356 5693 |
|
