Central bilge alarm monitoring and control module for four bilge compartments. Four individual audible & visual bilge high level alarms each with alarm acknowledge touch switch.  
Flashing red visual alarms, change to steady when acknowledged. Connects to four remote, 2PP bilge alarm sensing probe assemblies or float switches. Housed in sealed flush mount module with 48 x 96 mm dash footprint.
Download pdf

Central bilge monitoring and control system for four bilge compartments. Full LED backlit system status display including four sets of power on indications, pump run warnings, and bilge high level alarms.  
Sealed touch switches provide individual remote manual pump control and alarm acknowledge facilities plus common alarm test and dim functions. Inputs from four remote WS1 or WS96 local bilge control units with 3PP sensors or float switches.  
Housed in sealed flush mount module with 96 x 96 mm dash footprint.

The WS96 is a pre assembled, sealed junction box with plug-in terminals for pump, power, 3PP or 2x float switch level sensors, remote manual control input & status display outputs for WS4.
Download pdf

The WS1 is a pre assembled, sealed junction box with plug-in terminals for pump, power, 3PP or 2x float switch level sensors, remote manual control input & status display outputs for WS1 PIM module or as a local bilge control unit into a WS4 controller.
Download pdf

Single station, remote bilge alarm, pump control & status display module. Remote manual pump control output. Inputs from WS1 bilge controller or from pump and alarm float switches. 

* 2PP bilge alarm sensors are used in conjunction with the B4 bilge alarm controllers. 
* 3PP bilge pump on and high level alarm sensor used with WS1 and WS4 bilge controllers.  
* Heavy duty construction, 316 stainless sensing probes, encapsulated prewired enclosure.  
* No moving parts to jam, AC capacitance sensing signal to eliminate corrosion & plating. 

AIM BILGE CONTROLLER  

The AIM Bilge Controller utilizes the TLMP-98 level sensor to measure the bilge level. The AIM controller includes LED bilge level display, Pump Out Due and Pump Run warning, and Bilge High level alarm. Sealed touch switches for Manual Pump Start, Auto/Manual switch, toggles between Auto and Manual Pump out start mode. Auto Pump off, when bilge level drops. Plug in terminal on rear for power, sensor, remote alarm and remotepump control relay.

TLMP-98 BILGE LEVEL SENSOR

The AIM Bilge Controller utilizes the TLMP-98 level

BAVA

REMOTE AUDIBLE & VISUAL BILGE ALARM.