BILGE ALARM CONTROL SYSTEMS

Easy to use with LED backlit, bilge pump and bilge alarm status display for instant status recognition. Compact, good looking modules with sealed touch switch controls for greater reliability. Simple to install, with plug-in wiring termina, and wiring diagram on enclosure side, 12 or 24 VDC.

B4 – FOUR COMPARTMENT BILGE ALARM MODULE

  • Central bilge alarm monitoring and control module for four bilge compartments.
  • Four individual audible & visual bilge high level alarms each with alarm acknowledge touch switch.
  • Flashing red visual alarms, change to steady when acknowledged.
  • Connects to four remote, 2PP bilge alarm sensing probe assemblies or float switches to sense bilge level.
  • Housed in sealed flush mount module with 55 x 99 mm dash footprint x 125 mm deep.
  • Plug in terminal on rear for connection of power, remote alarm and four sensor inputs with system wiring drawing on the side.

WS2 – TWO COMPARTMENT BILGE PUMP & BILGE ALARM CONTROL SYSTEM

  • Central bilge alarm monitoring & bilge pump control system for two bilge compartments.
  • Full LED backlit system status display including two sets of power on indications, pump run warnings, and bilge high level alarms.
  • Sealed touch switches provide individual remote manual pump control and alarm acknowledge facilities plus common alarm test and dim functions.
  • Inputs from two remote WS1 bilge control units with 3PP sensors or float switches.
  • Housed in sealed flush mount module with 55 x 99 mm dash footprint x 125mm deep with system wiring drawing on the side. 

WS4 – FOUR COMPARTMENT BILGE PUMP & BILGE ALARM CONTROL SYSTEM

  • WS4 – FOUR COMPARTMENT BILGE PUMP & BILGE ALARM CONTROL SYSTEM
  • Central bilge monitoring & control system for four bilge compartments.
  • Full LED backlit system status display including four sets of power on indications, pump run warnings, pump on manually, and bilge high level alarms.
  • Sealed touch switches provide individual remote manual pump control and alarm acknowledge facilities plus common alarm test and dim functions.
  • Inputs from four WS1 remote bilge control units with 3PP sensors.
  • Housed in sealed flush mount module with 99 x 99 mm dash footprint x 130 mm deep.

WS1-V4 REMOTE BILGE PUMP & BILGE ALARM CONTROL

The WS1-V4 is a pre assembled, sealed junction box with plug-in terminals for pump, power, 3PP bilge level sensor or 2x float switch sensors, remote manual control input & full status display outputs to WS2 or WS4 centred units. The WS1-V4 has a 20 Amp pump control relay with antisplash delay and adjustable pump run timer to eliminate pump cycling.

3PP BILGE PUMP & ALARM, SENSOR

Use with WS1-V4 local bilge controller in conjunction with WS2 & WS4 bilge control systems.

  • Heavy duty construction, 316 stainless sensing probes, prewired and encapsulated.
  • No moving parts to jam, AC capacitance sense signal to eliminate corrosion & plating.

AIM-HTC BILGE CONTROLLER

The aim-htc bilge controller utilizes the TLMP-98 level sensor to measure the bilge level. The aim-htc controller includes led bilge level display, pump out due and pump run warning, and bilge high level alarm. Sealed touch switches for manual pump start, auto/manual switch, toggles between auto and manual pump out start mode. Auto pump off, when bilge level drops. Plug in terminal on rear for power, sensor, remote alarm and remote pump control relay.

TLMP-98 BILGE LEVEL SENSOR

Used in conjunction with the AIM HTC bilge controller. The TLMP-98 bilge level sensor measures the depth of liquid in the bilge. It provides a 4-20mA output to the AIM-HTC bilge controller proportional to the depth.