GS-2 TWO CIRCUIT GAS DETECTION, ALARM & LPG CONTROL.

The self contained flush mount GS 2 controller module, features LED backlit status display, 2x LED bargraphs of % LEL, sensor fault monitoring & warning, sealed touch switch controls for greater reliability, and plug-in terminals on the rear for simple installation of site wiring. Kit includes GS2 module, 2x gas sensor assemblies, 1x gas solenoid valve. Operation of gas on/off switch turns gas supply on and off, with audible and visual alarms and automatic gas shutoff if a gas leak is detected.

FD 2 TWO CIRCUIT FUME DETECTION, ALARM & FAN CONTROL

The self contained flush mount FD 2 controller module, features LED backlit status display, 2x LED bargraphs of % LEL, sensor fault monitoring & warning, sealed touch switch fan controls, alarm isolate/resets, test and dimmer.

Plug-in terminals on the rear simplify termination of site wiring. Kit includes FD 2 controller module & 2x gas sensor assemblies. Operation of either fan control on/off switch turns that blower fan on and off, with audible and visual alarms and automatic fan start if fumes are detected.

TS12 TWELVE SWITCH MODULE

Twelve sealed touch switch controls with LED On indication in each switch for control both local & remote equipment. Suitable for momentary or on/off control.12 or 24 volts DC. Plug-in terminals, with local relay driver outputs to drive remote switching relays.

NAVMON-8 NAVIGATION LIGHT FAULT MONITOR & CONTROL

Compact flush mount module provides touch switch on/off control of eight navigation lights, each with fault monitoring of the nav light circuit, with red LED visual & common audible, fault warnings, in case of bulb or circuit failure. A green nav light on LED is provided for each healthy nav light circuit on.

The fault monitoring is arranged in four groups (steaming, anchor & nuc. & no lights on when dark) with individual group fault acknowledge switches. 12 or 24 volts DC. Plug-in terminals on rear for wiring to remote control relays & stud mount sensing diode assemblies to be mounted in nav light switchboard.

TT2 TRIM TAB DISPLAY AND CONTROL

Single or dual station trim tab controller with 20 LED feedback position display & interlocked relay hydraulic control drives. Sealed touch switch, pairs of trim tab up and down switches.