Among its many features the W51 MKII Pump Controller
Module Includes
- Automatic bilge pump out control, with 20 amp switching capacity.
- Adjustable pump run timer to adjust compartment pump out
time.
- An antisplash delay to avoid false pump activation.
- Bilge high level alarm warnings.
- Sensitivity adjustments for pump and alarm control
- Low current AC sensing signal eliminates corrosion or plating
problems.
- Local LED status display of power on, pump on and high level
alarm.
- Touch switches manually start: the bilge pump out cycle and
test alarms.
- Provision for remote system status display, alarms and controls.
- 12 or 24 volt DC pump and system power supply with low current
draw of 30 mA on standby.
- Includes glanded junction box for all wiring. All terminals
and functions identified on the module bookplate.
- Simple installation with plug in terminals.
|
A model option includes an independent, heavy duty, three position
(Auto-Off-Manual) rotary manual pump control switch.
Click on the image below to view in full size
An optional WS1 PIM module, for installation in the
wheelhouse, provides LED backlit system status display, sealed touch
switch pump and alarm controls, all housed in a compact (66 x 96mm)
flush mounted module, with plug in terminals for wiring to the remote
WS1 controller.
With this system, your pump life is extended because
the compartment [a pumped to empty each pump cycle, rather than repeatedly
being switched on and off as with a float switch; and with no moving
parts to jam or break down, it provides superior bilge pump control.
Innovative Technology for Industry and Marine
P.O. Box 218 Red Hill, Qld 4059, Australia
|
4 Cramond Street, Wilston,
Qld 4051, Australia
ISD + 61 7. Phone (07) 3356 1276. Fax (07) 3356 5693 |
